QCAD Bugtracker

  • Status Closed
  • Percent Complete
  • Task Type Bug Report
  • Category QCAD (main)
  • Assigned To
  • Operating System All
  • Severity Low
  • Priority Very Low
  • Reported Version 3.21.3
  • Due in Version Undecided
  • Due Date Undecided
  • Votes
  • Private
Attached to Project: QCAD Bugtracker
Opened by Adam Zalonis - 13.01.2019
Last edited by Andrew - 13.01.2019

FS#1845 - Block reference points cannot be supressed in printer output/print-preview

Drawing preferences have no effect on point type when printed or in print-preview for block reference points.
Notice in “print output”, the “Dot” (Block reference point) is displayed (drawing preferences are ignored).

See attached photos.

Closed by  Andrew
13.01.2019 21:04
Reason for closing:  Not a bug
Additional comments about closing:  

Intended behavior

Andrew commented on 13.01.2019 21:04

This is intended behavior. The block display preferences only affect the display, not the print. Accordingly, the point sizes are in pixels (for the screen).


Available keyboard shortcuts


Task Details

Task Editing