- Status Assigned
- Percent Complete
- Task Type Feature Request
- Category QCAD (main)
-
Assigned To
Andrew - Operating System All
- Severity Low
- Priority Very Low
- Reported Version 3.22.0
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
FS#1870 - Stretch tool / option to turn selection restriction on/off
Hi,
since 3.19.2 the Stretch tool looks for any selection and follows the specification “Only stretch selected entities if there is a selection”.
That is a nice feature but it leads many times to confusing because I have to deselect a selection just because I need to use the stretch tool on something else on the fly. The same if I “forgot” a selection outside of my zoom which is still important for me. The stretch tool just won’t work without any message why not. My routine now is that I terminate every selection just before I use the stretch tool just not to be surprised by “why isn’t it working”?
It would be nice to have in the Stretch option bar a checkbox to turn the “only selection feature” on or off. QCAD should remember that setting.