- Status Assigned
- Percent Complete
- Task Type Feature Request
- Category QCAD/CAM
-
Assigned To
Andrew - Operating System All
- Severity Low
- Priority Very Low
- Reported Version 3.22.1
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: QCAD Bugtracker
Opened by H. Stiekema - 13.06.2019
Last edited by Andrew - 13.06.2019
Opened by H. Stiekema - 13.06.2019
Last edited by Andrew - 13.06.2019
FS#1902 - CAM G-Block Toolpath
Hallo Andrew,
Still busy on the never ending G-code story. Urgently needed the very handy G-code Block Toolpath. This ‘toolpath’ also solves a lot of “editing requests”.