QCAD Bugtracker

  • Status Closed
  • Percent Complete
  • Task Type Bug Report
  • Category QCAD (main)
  • Assigned To
  • Operating System All
  • Severity Low
  • Priority Very Low
  • Reported Version Development
  • Due in Version Undecided
  • Due Date Undecided
  • Votes
  • Private
Attached to Project: QCAD Bugtracker
Opened by Peter - 26.08.2011
Last edited by Andrew - 13.09.2011

FS#191 - SVG PG export text vertical and horizontal alignment

QCAD offers horizontal and vertical alignment choices for text. This is not carried over to PG exported SVGs. Currently QCAD sets the “dy” attribute on text nodes in a way, such that any text in SVG will look like the QCAD vertical alignment was set to “Top” and the horizontal one to “Left”.

Naively one can just omit the “dy” attribute and in SVG this will look like the QCAD vertical alignment was set to “bottom”. At least for single line texts that should be good.

The horizontal alignments can be recreated in SVG with the “text-anchor” attribute for text nodes. The values “start”, “middle” and “end” correspond to the QCAD “left”, “center” and “right” choices.

Closed by  Andrew
13.09.2011 12:26
Reason for closing:  Fixed
Additional comments about closing:  



Available keyboard shortcuts


Task Details

Task Editing