- Status Assigned
- Percent Complete
- Task Type Feature Request
- Category QCAD/CAM
-
Assigned To
Andrew - Operating System All
- Severity Low
- Priority Very Low
- Reported Version 3.22.1
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: QCAD Bugtracker
Opened by H. Stiekema - 02.07.2019
Last edited by Andrew - 04.07.2019
Opened by H. Stiekema - 02.07.2019
Last edited by Andrew - 04.07.2019
FS#1911 - Drill Toolpath
Hallo Andrew
It would be more than conveniant, defining the drilling locations of the drill toolpath, by selecting a circle’s center point.