- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD (main)
-
Assigned To
Andrew - Operating System Windows 7
- Severity Low
- Priority Very Low
- Reported Version 3.23.0
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
FS#1924 - SweepAngle = 0
Win7pro 32bit Wininstaller Qcadpro 3.23.0
Draw an arc.
Select the arc.
In Property Editor:
Set start angle to 135
Set end angle to 135
SweepAngle = */-360
edit the end angle and add “+360”, hit enter
SweepAngle = 0
An arc with zero sweep is a point.
A point is not an arc.
With the same start and end parameter an arc should have a sweep of +/-360.
As for entries by points or by angles.
Regards