- Status Assigned
- Percent Complete
- Task Type Feature Request
- Category QCAD (main)
-
Assigned To
Andrew - Operating System All
- Severity Low
- Priority Very Low
- Reported Version 3.23.0
- Due in Version Undecided
-
Due Date
Undecided
-
Votes
1
- Günther Gräbner (08.08.2019)
- Private
FS#1926 - No negative coordinate values ? (DO command)
Just starting with QCAD, for some hours now - really excellent user interface (compared to other low budget CADs, like DCAD, or BeckerCAD...) !
Surprisingly, point coordinates - entered via the command line, and shown with correct positions on the drawing- are not displayed correctly with the ‘dimordinate’ (DO) command.
There are no negative values, even when the center point (0;0) is right in the middle of the drawing, so points left and below should have !
GW.G
This is intended behaviour. The distance to the reference point is measured.
It might be possible to add an option / preference / entity property in a future version to allow for negative values (depending on support in other CAD systems).
Changed to feature request.
Ordinates are strickt positive.
Most CAD get this question, some adapt.