QCAD Bugtracker

  • Status Assigned
  • Percent Complete
    0%
  • Task Type Feature Request
  • Category QCAD (main)
  • Assigned To
    Andrew
  • Operating System All
  • Severity Low
  • Priority Very Low
  • Reported Version 3.23.0
  • Due in Version Undecided
  • Due Date Undecided
  • Votes 1
  • Private
Attached to Project: QCAD Bugtracker
Opened by Günther Gräbner - 03.08.2019

FS#1926 - No negative coordinate values ? (DO command)

Just starting with QCAD, for some hours now - really excellent user interface (compared to other low budget CADs, like DCAD, or BeckerCAD...) !

Surprisingly, point coordinates - entered via the command line, and shown with correct positions on the drawing- are not displayed correctly with the ‘dimordinate’ (DO) command.
There are no negative values, even when the center point (0;0) is right in the middle of the drawing, so points left and below should have !

GW.G

Admin
Andrew commented on 04.08.2019 20:39

This is intended behaviour. The distance to the reference point is measured.

It might be possible to add an option / preference / entity property in a future version to allow for negative values (depending on support in other CAD systems).

Changed to feature request.

CVH commented on 05.08.2019 05:51

Ordinates are strickt positive.
Most CAD get this question, some adapt.

Loading...

Available keyboard shortcuts

Tasklist

Task Details

Task Editing