- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD (main)
-
Assigned To
Andrew - Operating System All
- Severity Low
- Priority Low
- Reported Version 3.23.0
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: QCAD Bugtracker
Opened by Ian Howell - 27.08.2019
Last edited by Andrew - 27.08.2019
Opened by Ian Howell - 27.08.2019
Last edited by Andrew - 27.08.2019
FS#1937 - Circle shown in QCAD but not in AutoCAD
The attached drawing shows two large concentric circles when viewed in QCAD but the inner circle is missing when viewed in other CAD programmes. This cost $50 in rework as my laser cutting was not cut correctly!
Ring Test.dxf
(101.1 KiB)
The inner circle is not a circle but an arc with start angle at 184.582568 and end angle at 184.582568. Change to a circle to better compatibility.