- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD (main)
-
Assigned To
Andrew - Operating System All
- Severity Low
- Priority Very Low
- Reported Version 3.23.0
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: QCAD Bugtracker
Opened by tukuyomi - 26.09.2019
Last edited by Andrew - 01.10.2019
Opened by tukuyomi - 26.09.2019
Last edited by Andrew - 01.10.2019
FS#1945 - Splines saved incorrectly
Closed splines (Control points) are saved as “not closed” with a new knot (when DXF is closed and re-opened).
Is this behavious intended ?
Yes, this is a known limitation. The shape should not be affected by this.