- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD (main)
-
Assigned To
Andrew - Operating System All
- Severity Low
- Priority Very Low
- Reported Version 3.23.0
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: QCAD Bugtracker
Opened by Christoph Kukulies - 01.10.2019
Last edited by Andrew - 01.10.2019
Opened by Christoph Kukulies - 01.10.2019
Last edited by Andrew - 01.10.2019
FS#1949 - Modify > Break out: Leftover (zero length line) after using tool on ray
When using D2 on the vertical line (orange line in the attached example) a small zero length line is left over. This doesn’t happen if the vertical orangle line were a finite, line with two distinct endpoints.
Closed by Andrew
01.10.2019 07:21
Reason for closing: Fixed
Additional comments about closing:
01.10.2019 07:21
Reason for closing: Fixed
Additional comments about closing:
https://github.com/qcad/qcad/commit /c28613af52284bec66bc768c2a86630bf83c9f4 4