- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD (main)
-
Assigned To
Andrew - Operating System All
- Severity Low
- Priority Very Low
- Reported Version 3.23.0
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: QCAD Bugtracker
Opened by Larry Buller - 12.10.2019
Last edited by Andrew - 17.10.2019
Opened by Larry Buller - 12.10.2019
Last edited by Andrew - 17.10.2019
FS#1969 - font name not saving correctly
0
STYLE
5
31D
330
239
100
AcDbSymbolTableRecord
100
AcDbTextStyleTableRecord
2
textstyle11
70
0
40
0.0
41
1.0
50
0.0
71
0
42
0.2
3
CASTELAR.TTF
4
1001
ACAD
1000
Castellar
1071
0
1.DXF
(189.5 KiB)
Closed by Andrew
17.10.2019 14:04
Reason for closing: Not a bug
Additional comments about closing:
17.10.2019 14:04
Reason for closing: Not a bug
Additional comments about closing:
Please request a re-open if you still
think this is a bug. Please provide
further information in this case,
thanks.
the font is Castellar.ttf the 3 group code leaves out one L making it castelar.ttf
the 1000 groupcode has the spelling correct as Castellar
Could it be that the font file name (on disk) is "CASTELAR.TTF"?
I'm thinking about the 8.3 file name limitation also.
I have confirmed that Castellar.ttf is the correct name. If the name contained in the 1000 groupcode is consistent, then I can use that instead of the 3 groupcode name. Could you confirm that is how QCAD works?
What is the logic to remove a letter in the middle of a name? I did not see any restriction to 8.3 in the Autodesk 2012 dxf reference.
This is all handled by the OpenDesign Teigha libraries, not QCAD. I don't know what the logic is behind the .ttf file name saved to DXF. I would have expected that to match the file name on disk.