QCAD Bugtracker

  • Status Assigned
  • Percent Complete
    0%
  • Task Type Feature Request
  • Category QCAD (main)
  • Assigned To
    Andrew
  • Operating System All
  • Severity Low
  • Priority Very Low
  • Reported Version 3.23.0
  • Due in Version Undecided
  • Due Date Undecided
  • Votes
  • Private
Attached to Project: QCAD Bugtracker
Opened by Husky - 19.10.2019

FS#1977 - Corresponding coordinate format

Hi,

It would be less confusing to read messages in the command line protocol if it would use the same coordinate separators like the settings below Application Preferences / General / Coordinate Format.

This example shows the “Absolute Cartesian Coordinate” but of course all corresponding format settings should be used within messages.

Absolute Cartesian Coordinate: Setting = semicolon (;) but the message will use division (/).

Loading...

Available keyboard shortcuts

Tasklist

Task Details

Task Editing