FS#1983 - Trim All or Bulk Break out
This is a trim method I am missing in Qcad.
20 years ago it existed in CadKey.
You had a bunch of lines or segments.
You defined a (new) line or segment as cutter.
‘Trim All’.
You pointed at the side of the cutter entity to trim all intersecting at that side.
Pritty the same as in this topic:
https://qcad.org/rsforum/viewtopic.php?t=5221
Only in rare cases I can use Husky’s workaround as pro.
It all depends on what else is in the clipping rectangle that is needed to trim all intended.
If of no use all single crossing entities have to be chosen one by one.
Regards,
CVH