- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD (main)
-
Assigned To
Andrew - Operating System All
- Severity Low
- Priority Very Low
- Reported Version 3.24.2
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Opened by John Hyslop - 21.01.2020
Last edited by Andrew - 03.06.2020
FS#2031 - Ordinate Dimensions don't act as expected
Hi Andrew
I wasn’t sure if this was a bug or feature request, when I’m drawing part sets that only change in lengths I dimension them
to save time then I stretch and save as whatever filename... I was surprised when Qcad reacted the way it did when stretching ordinate
dimensions on a part, the 1st thing I did was window select over the dimensions which didn’t work ( this is the typical way for
stretching ordinate dimensions in AutoCAD,IntelliCad,Draftsight etc )... anyway Husky and I had a fairly long debate and he told me
I had to select the object and only parts of the ordinate dimensions which when stretched leaves a bit of tidying up to do..
Please let me know if I’m going about this the wrong way.. do i really have to do multiple stretches and move all the jogged dimensions?
See Topic https://www.qcad.org/rsforum/viewtopic.php?f=32&t=6901&start=15 It started off with negative values for ordinate dimensions then turned into problems stretching ordinate dimensions..
I also posted dropbox links to quite a few videos..
Attached is a zip file containing some screenshots plus the original dxf file..
Best Regards
John Hyslop