- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD/CAM
-
Assigned To
Andrew - Operating System Linux (All / Other)
- Severity Low
- Priority Very Low
- Reported Version 3.24.2
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: QCAD Bugtracker
Opened by Jonas Bauman - 25.01.2020
Last edited by Andrew - 31.08.2020
Opened by Jonas Bauman - 25.01.2020
Last edited by Andrew - 31.08.2020
FS#2033 - Repeated warning message while updating toolpath
While updating or regenerating toolpath on the attached dxf file I repeatedly get the warning message in the attached jpg file. If I keep clicking OK then the toolpath is successfully generated. This did not happen in version 3.23.0 with the same file.
Workaround: Please make sure that Edit > Application Preferences > Widgets > Command Line > Show warnings as dialogs is switched off.