QCAD Bugtracker

  • Status Closed
  • Percent Complete
  • Task Type Bug Report
  • Category QCAD (main)
  • Assigned To
  • Operating System All
  • Severity Low
  • Priority Medium
  • Reported Version 3.24.2
  • Due in Version Undecided
  • Due Date Undecided
  • Votes
  • Private
Attached to Project: QCAD Bugtracker
Opened by Andrew - 03.02.2020
Last edited by Andrew - 03.02.2020

FS#2038 - Cannot snap arc / circle reference points inside blocks

- Create block with arc or circle
- Auto snap / reference snap does not snap to reference points at circle / arc max / min coordinates

Closed by  Andrew
03.02.2020 13:34
Reason for closing:  Fixed
08.02.2020 : A request to re-open the task has been made. Reason for request: This is also affecting end points of lines within blocks, if the autosnap is set to reference points. I am almost certain this was not a fault until recently. thanks Barry W.


Available keyboard shortcuts


Task Details

Task Editing