- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD (main)
-
Assigned To
Andrew - Operating System All
- Severity Low
- Priority Very Low
- Reported Version 3.24.3
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: QCAD Bugtracker
Opened by Husky - 18.05.2020
Last edited by Andrew - 18.05.2020
Opened by Husky - 18.05.2020
Last edited by Andrew - 18.05.2020
FS#2077 - Property Editor / Fixed Extension Line fails in certain cases
If I edit a DIM regarding the fixed Extension Line Length it will fail if it has to be extended to meet the new length. Even it has failed - the Property Editor will provide from now on the new length as the “correct” value for the Extension Line Length.
Example drawing: Try to adjust the Extension Line Length to 50 ...
The extension line never extends further than the dimensioned feature (or referenced point). I.e. this property can only be used to shorten extension lines, not lengthen them.