QCAD Bugtracker

  • Status Assigned
  • Percent Complete
    0%
  • Task Type Feature Request
  • Category QCAD (main)
  • Assigned To
    Andrew
  • Operating System All
  • Severity Low
  • Priority Very Low
  • Reported Version 3.25.2
  • Due in Version Undecided
  • Due Date Undecided
  • Votes 2
  • Private
Attached to Project: QCAD Bugtracker
Opened by Russell Ault - 29.10.2020

FS#2127 - Snap for predicted intersections while using "Restrict Angle or Length"

I would like to request a new kind of snap: a “Restricted Intersection” snap that appears at the point where an entity would intersect with a line drawn from Relative Zero that fulfills the current EL criteria. “Restricted Intersection” snaps would be similar to other Relative Zero-based snaps (like “Perpendicular” and “Tangential”), but would predict the point of the snap from the EL constraints instead of the characteristics of the entity being snapped to. Naturally a value of 0 for angle or length would result in that constraint being ignored.

Additional operational flexibility could be achieved by allowing the snap to exist regardless of whether EL is actually in use. To be useful this would probably require determining snap locations based on angle OR length as opposed to angle AND length.

Implementing this new snap would allow, for example, for easily drawing a line of unknown (but determinable) length at a specified angle between a given point and a given entity (see discussion here), with the “Restricted Intersection” snap ensuring that the endpoint of the new line forms an intersection with the entity in question. Currently the same goal can be achieved a couple of different ways, but they all involve at least two separate steps.

Loading...

Available keyboard shortcuts

Tasklist

Task Details

Task Editing