QCAD Bugtracker

  • Status Closed
  • Percent Complete
  • Task Type Bug Report
  • Category QCAD (main)
  • Assigned To
  • Operating System Windows XP
  • Severity Low
  • Priority Very Low
  • Reported Version Development
  • Due in Version Undecided
  • Due Date Undecided
  • Votes
  • Private
Attached to Project: QCAD Bugtracker
Opened by Anonymous Submitter - 29.08.2011
Last edited by Andrew - 29.08.2011

FS#214 - Adding dimensions to circles or arcs in a block

In previous versions I was able to add a diametric dimension to an arc or circle that is part of a block in the overal drawing.
When I try this now, the pogram resonds “Entity is not an arc or circle” the radius dimension gives the same error.
This is unfortunate, because typically dimensions are on another layer in the overal drawing.

Closed by  Andrew
29.08.2011 18:19
Reason for closing:  Fixed
Additional comments about closing:  



Available keyboard shortcuts


Task Details

Task Editing