- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD (main)
-
Assigned To
Andrew - Operating System All
- Severity Low
- Priority Very Low
- Reported Version 3.26.0
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: QCAD Bugtracker
Opened by Matthijs Kooijman - 08.03.2021
Last edited by Andrew - 08.03.2021
Opened by Matthijs Kooijman - 08.03.2021
Last edited by Andrew - 08.03.2021
FS#2201 - Purge blocks while editing block in place removes block being edited
I was editing a block using the “Edit block in-place” and then (because I was exploring QCad a little) tried the “Purge unused blocks” option. I suspect that the purge removed the block I was editing, since when I now click “Save and close”, I get “Original block not found”. Also when I click “Cancel”, I get “Original block reference data not found”.
Recreating an empty block with the same name fixes this, and “Save and close” seems to work as expected again.
This is probably very much a corner case which is not really important, but I wanted to report it just so it is known.
Thanks. We've improved this case by aborting the in-place block edit and leaving the contents in place as is and an appropriate warning.