QCAD Bugtracker

  • Status Assigned
  • Percent Complete
  • Task Type Feature Request
  • Category QCAD (main)
  • Assigned To
  • Operating System All
  • Severity Low
  • Priority Very Low
  • Reported Version 3.26.2
  • Due in Version Undecided
  • Due Date Undecided
  • Votes
  • Private
Attached to Project: QCAD Bugtracker
Opened by Husky - 19.04.2021

FS#2229 - Property Editor, option format property values as decimal numbers

Angle Display is decimal although the decimal display is disabled in Application Preferences.

Format should be 17° 31’ 52” instead of 17.531111.

Andrew commented on 19.04.2021 07:48

I can confirm that this is not implemented.

CVH commented on 10.05.2021 10:42

Seems one can't have it both ways.
Proper (subjective) or rather correct.

- Radians is the best option: 1ULP of 0-2pi is up to 8,882e-16 off.
- Then comes decimal degrees: 1ULP of 0-360° is up to 5,684e-14 off.
- Degrees-minutes-seconds: 1ULP is 1 second or up to 2,778e-4 off.
Adding fractions of seconds isn't a solution either:
e.g. 1ULP is 1/100 second or up to 2,778e-6 off.

Values in the property editor aren't formatted with a comma either if that is the native preference.



Available keyboard shortcuts


Task Details

Task Editing