- Status Assigned
- Percent Complete
- Task Type Bug Report
- Category QCAD (main)
-
Assigned To
Andrew - Operating System All
- Severity Low
- Priority Very Low
- Reported Version 3.26.4
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
FS#2289 - Vertical Line Tool stops accepting input
When using the vertical line tool, you can enter a length value in the options toolbar, then place the line. If you want to change the length, you just need to enter a new value and the length field will update. However, there seem to be cases where after 10-20 entries, the focus goes off the length field in the options toolbar, requiring the user to bring focus back to continue. I could not seem to duplicate this behavior with the horizontal line tool.
Ryan,
I couldn't recreate that under 3.27 PRO on a Win7 32bit machine.
Did over 30 entries and still the options toolbar takes new lengths.
Messed with snapping points, changed tab focus and changed back, and so on ...
Then I wanted to test a false key stroke and entered an 'a'.
From that point on nor LV nor LH take new entries.
Ctrl+Space is now required every input.
It required a reboot to get back to the 'default' behaviour.
Regards,
CVH