FS#2417 : Insert Measurement/e.g. d1 Point to Point fails within Coordinate (SX) Snap

Status Closed
Percent Complete
100%
Task Type Bug Report
Category QCAD (main)
Assigned To

andrew
Operating System All
Severity Low
Priority Very Low
Reported Version 3.27.8
Due in Version Undecided
Due Date Undecided
Votes
Private

Attached to Project: QCAD Bugtracker
Opened by Husky - 31.10.2022
Last edited by andrew - 03.11.2022

FS#2417 - Insert Measurement/e.g. d1 Point to Point fails within Coordinate (SX) Snap

Insert Measurement / e.g. Point to Point fails within Coordinate (SX) dialog. It is offered for X and Y but I can’t find a way to use it. For a proper measurement with IP I need to use Autosnap etc. but that means I have to switch from Coordinate snap to an other snap with no way to return to use the d1 variable.