QCAD Bugtracker

  • Status Closed
  • Percent Complete
  • Task Type Bug Report
  • Category QCAD (main)
  • Assigned To
  • Operating System Ubuntu Linux
  • Severity Medium
  • Priority Very Low
  • Reported Version 3 Beta
  • Due in Version Undecided
  • Due Date Undecided
  • Votes
  • Private
Attached to Project: QCAD Bugtracker
Opened by Bob - 09.09.2011
Last edited by Andrew - 12.09.2011

FS#252 - Displayed line thickness too thick.

This manifestation happened after I had loaded an existing drawing, made modifications, then used print preview and adjusted the scale to fit the paper.

The file was closed. Upon reopening lines designated as .25mm were unusually thick such that two lines 2mm apart appeared as one solid line. Placing the cursor over the line showed it was comprised of two lines.

Changing the properties of a line to make it thinner did not help with one exception and that was to set the line thickness to default, when the two lines became visible.

Closed by  Andrew
12.09.2011 18:31
Reason for closing:  Duplicate
Additional comments about closing:  


Peter commented on 12.09.2011 18:27

see  FS#199 


Available keyboard shortcuts


Task Details

Task Editing