QCAD Bugtracker

  • Status Closed
  • Percent Complete
  • Task Type Bug Report
  • Category QCAD (main)
  • Assigned To
  • Operating System All
  • Severity Low
  • Priority Very Low
  • Reported Version 3 RC1
  • Due in Version Undecided
  • Due Date Undecided
  • Votes
  • Private
Attached to Project: QCAD Bugtracker
Opened by Peter - 05.11.2011
Last edited by Andrew - 07.11.2011

FS#368 - Appearance preference

RC1 is lazy in saving appearance to config. I noticed, because it always started with default window size. Maximizing was not carried over, also the panels were consistently reset.

Only when eg. dragging the handle to change cad-toolbar width not from preferences it would write an “appearance” section to the config file.

The appearance section should be written rather sooner than later.

Closed by  Andrew
07.11.2011 19:23
Reason for closing:  Not a bug
Andrew commented on 05.11.2011 19:39

Apearance (window size, position, panels, etc.) are saved on exit. Could it be that QCAD did not terminate properly (e.g. crash or Ctrl-C in terminal)?

Peter commented on 05.11.2011 23:12

I often "quit" from the terminal so it may well be, that this was it, as this will produce such a short config.file. Not doing so in fact includes appearance. so please close.

Because you mention that, I want to tell, crashes have been very rare from tp1 on and disappeared at all in more recent versions.


Available keyboard shortcuts


Task Details

Task Editing