- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD (main)
-
Assigned To
Andrew - Operating System All
- Severity Medium
- Priority Very Low
- Reported Version Development
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: QCAD Bugtracker
Opened by Anonymous Submitter - 29.04.2011
Last edited by Andrew - 02.05.2011
Opened by Anonymous Submitter - 29.04.2011
Last edited by Andrew - 02.05.2011
FS#40 - saving spline CP, 2deg, closed hits assert
- new file
- draw spline CP, 2deg, closed
- save → crash
Debug: "RDwgServices::printErrorStackTrace: General modeling failure" Warning: RDwgExporter::exportEntity: Exception occured. Entity NOT saved: RSplineEntity(REntity(RObject(id: 23, document: "0xb246720", address: "0xb915f00", undone: 0), type: 23, layerId: 21, blockId: 22, lineweight: -1, linetypeId: 0, color: RColor(ByLayer) , drawOrder: 0 , selectionStatus: false ) controlPoints (6): 0: RVector(14, 21, 0) 1: RVector(41, 25, 0) 2: RVector(41, 9, 0) 3: RVector(28, 4, 0) 4: RVector(14, 21, 0) 5: RVector(41, 25, 0) fitPoints (0): knots (7): 0: -1, 1: 0, 2: 1, 3: 2, 4: 3, 5: 4, 6: 5, ) Fatal: ASSERT: "false" in file RDwgExporter.cpp, line 1234
Thread [1] 2066 (Suspended : Signal : SIGABRT:Aborted) __kernel_vsyscall() at 0xffffe424 raise() at 0xb4f037ff abort() at 0xb4f05140 RMainWindow::messageHandler() at RMainWindow.cpp:63 0x8e025a6 qt_message_output() at 0xb5357f65 0xb53581ab qFatal() at 0xb53582c9 qt_assert() at 0xb5358355 RDwgExporter::exportEntity() at RDwgExporter.cpp:1,234 0x8cb754f RExporter::exportEntities() at RExporter.cpp:408 0x8de5c96 <...more frames...>
same problem with cubic closed splines