QCAD Bugtracker

  • Status Closed
  • Percent Complete
    100%
  • Task Type Bug Report
  • Category QCAD (main)
  • Assigned To
    Andrew
  • Operating System All
  • Severity Medium
  • Priority Very Low
  • Reported Version Development
  • Due in Version Undecided
  • Due Date Undecided
  • Votes
  • Private
Attached to Project: QCAD Bugtracker
Opened by Anonymous Submitter - 29.04.2011
Last edited by Andrew - 02.05.2011

FS#40 - saving spline CP, 2deg, closed hits assert

  1. new file
  2. draw spline CP, 2deg, closed
  3. save → crash
Debug:    "RDwgServices::printErrorStackTrace: General modeling failure" 
Warning:  RDwgExporter::exportEntity: Exception occured. Entity NOT saved: 
 RSplineEntity(REntity(RObject(id: 23, document: "0xb246720", address: "0xb915f00", undone: 0), type: 23, layerId: 21, blockId: 22, lineweight: -1, linetypeId: 0, color: RColor(ByLayer) , drawOrder:  0 , selectionStatus:  false ) 
controlPoints (6): 0: RVector(14, 21, 0) 1: RVector(41, 25, 0) 2: RVector(41, 9, 0) 3: RVector(28, 4, 0) 4: RVector(14, 21, 0) 5: RVector(41, 25, 0) 
fitPoints (0): 
knots (7): 0: -1, 1: 0, 2: 1, 3: 2, 4: 3, 5: 4, 6: 5, )
Fatal:    ASSERT: "false" in file RDwgExporter.cpp, line 1234
Thread [1] 2066 (Suspended : Signal : SIGABRT:Aborted)	
	__kernel_vsyscall() at 0xffffe424	
	raise() at 0xb4f037ff	
	abort() at 0xb4f05140	
	RMainWindow::messageHandler() at RMainWindow.cpp:63 0x8e025a6	
	qt_message_output() at 0xb5357f65	
	0xb53581ab	
	qFatal() at 0xb53582c9	
	qt_assert() at 0xb5358355	
	RDwgExporter::exportEntity() at RDwgExporter.cpp:1,234 0x8cb754f	
	RExporter::exportEntities() at RExporter.cpp:408 0x8de5c96	
	<...more frames...>	
Closed by  Andrew
02.05.2011 20:23
Reason for closing:  Fixed
Admin
Andrew commented on 02.05.2011 20:10

same problem with cubic closed splines

Loading...

Available keyboard shortcuts

Tasklist

Task Details

Task Editing