QCAD Bugtracker

  • Status Closed
  • Percent Complete
  • Task Type Bug Report
  • Category QCAD (main)
  • Assigned To
  • Operating System All
  • Severity Low
  • Priority Very Low
  • Reported Version 3 RC3
  • Due in Version Undecided
  • Due Date Undecided
  • Votes
  • Private
Attached to Project: QCAD Bugtracker
Opened by Dave Macfarlane - 01.01.2012
Last edited by Andrew - 27.02.2012

FS#446 - Polyline Offset ("Equidistant" in QCAD2) malfunctions depending on shape

Polyline/Offset tool sometimes does not generate equidistant polyline(s) correctly. Often, not always, only affects generation of the equidistant polyline(s) on ONE side of the original. A necessary condition to reproduce bug seems to be a polyline that contains a mixture of acute and obtuse angles between segments; number of segments, and whether figure is closed or not, also seem to affect appearance of bug. I have observed same behaviour in QCAD3 RC3 under Windowxs XP, and RC2 under Linux.

Closed by  Andrew
27.02.2012 15:38
Reason for closing:  Fixed
Additional comments about closing:  



Available keyboard shortcuts


Task Details

Task Editing