- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD (main)
-
Assigned To
Andrew - Operating System All
- Severity Low
- Priority Very Low
- Reported Version 3 RC2
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: QCAD Bugtracker
Opened by Stefan - 15.01.2012
Last edited by Andrew - 15.01.2012
Opened by Stefan - 15.01.2012
Last edited by Andrew - 15.01.2012
FS#466 - unwanted auto-inserted layer on save
after saving with qcad3 and re-opening, sometimes there is an additional layer “Defpoints” for unknown reason (qcad2 did not, qcad3 does not always)
Closed by Andrew
15.01.2012 13:27
Reason for closing: Won't fix
Additional comments about closing:
15.01.2012 13:27
Reason for closing: Won't fix
Additional comments about closing:
This is a DXF/DWG format detail and
cannot be changed.
It's very irritating because QCad2 does not add this layer (both tried with "save as dxf").