QCAD Bugtracker

  • Status Closed
  • Percent Complete
  • Task Type Bug Report
  • Category QCAD (main)
  • Assigned To
  • Operating System All
  • Severity Low
  • Priority Very Low
  • Reported Version 3 RC3
  • Due in Version Undecided
  • Due Date Undecided
  • Votes
  • Private
Attached to Project: QCAD Bugtracker
Opened by Peter - 28.01.2012
Last edited by Andrew - 06.02.2012

FS#476 - Stretching dimension

Draw a horizontal dimension. Stretch (S S) it. The label remains in place. It should instead go to the new center. (Unless it was manually positioned perhaps...)

Workaround: Pick one extension and drop it to where it was, label gets centered.

Closed by  Andrew
06.02.2012 14:52
Reason for closing:  Not a bug
Andrew commented on 06.02.2012 13:35

Not reproducible with QCAD 3 RC3, Windows 7.

Could this only be the case for drawings imported from QCAD 2?

Peter commented on 06.02.2012 14:51

I now realise, that this only happens with one single drawing. Maybe I have done something stupid. Please close.


Available keyboard shortcuts


Task Details

Task Editing