- Status Assigned
- Percent Complete
- Task Type Feature Request
- Category QCAD (main)
-
Assigned To
Andrew - Operating System All
- Severity Low
- Priority Very Low
- Reported Version 3 RC3
- Due in Version Post 3.0
-
Due Date
Undecided
- Votes
- Private
Attached to Project: QCAD Bugtracker
Opened by Andrew - 17.02.2012
Last edited by Andrew - 27.02.2012
Opened by Andrew - 17.02.2012
Last edited by Andrew - 27.02.2012
FS#503 - Convert entities to points with a fixed distance
Select lines, arcs, ... and convert them to points along the lines, arcs, ... with a fixed distance.
See also forum at:
http://www.ribbonsoft.com/rsforum/viewtopic.php?t=1834
Thanks Andrew, I definitely love this idea!
Found the old (locked) topic by the feature requests.
I could implement a FlexPainter set that places points or little circles along a base entity at a given repetitive distance or even dynamically spaced.
Such will be included for a next release of FlexPainter ... If time permits.
Then again, this is basically covered by 'Paste along Entity' (PE).
Regards,
CVH