- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD (main)
-
Assigned To
Andrew - Operating System Ubuntu Linux
- Severity Low
- Priority Very Low
- Reported Version 3 RC5
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: QCAD Bugtracker
Opened by Stefan - 12.04.2012
Last edited by Andrew - 16.12.2013
Opened by Stefan - 12.04.2012
Last edited by Andrew - 16.12.2013
FS#544 - Hatch not restored correctly in undo operation after scale
Scaling some entities including hatches and undo-ing this, the hatches are not restored correctly (still existing, but completely malformed).
Closed by Andrew
16.12.2013 13:25
Reason for closing: Fixed
Additional comments about closing:
16.12.2013 13:25
Reason for closing: Fixed
Additional comments about closing:
This has been fixed in QCAD 3.1.5
This happens likely after a scale operation with different X / Y factors and has to do with arcs not being scalable disproportionally (they would have to be changed into ellipses which is not implemented yet).
TODO:
The best solution for now might be to disable disproportional scaling for hatches with arc / ellipse segments.
Thank you for the response, but I didn't had disproportional scaling enabled.