QCAD Bugtracker

  • Status Closed
  • Percent Complete
  • Task Type Bug Report
  • Category QCAD (main)
  • Assigned To
  • Operating System Ubuntu Linux
  • Severity Low
  • Priority Very Low
  • Reported Version 3 RC5
  • Due in Version Undecided
  • Due Date Undecided
  • Votes
  • Private
Attached to Project: QCAD Bugtracker
Opened by Stefan - 12.04.2012
Last edited by Andrew - 16.12.2013

FS#544 - Hatch not restored correctly in undo operation after scale

Scaling some entities including hatches and undo-ing this, the hatches are not restored correctly (still existing, but completely malformed).

Closed by  Andrew
16.12.2013 13:25
Reason for closing:  Fixed
Additional comments about closing:  

This has been fixed in QCAD 3.1.5

Andrew commented on 25.04.2012 17:53

This happens likely after a scale operation with different X / Y factors and has to do with arcs not being scalable disproportionally (they would have to be changed into ellipses which is not implemented yet).

The best solution for now might be to disable disproportional scaling for hatches with arc / ellipse segments.

Stefan commented on 26.04.2012 17:29

Thank you for the response, but I didn't had disproportional scaling enabled.


Available keyboard shortcuts


Task Details

Task Editing