- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD (main)
-
Assigned To
Andrew - Operating System All
- Severity Low
- Priority Defer
- Reported Version 2.x
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Attached to Project: QCAD Bugtracker
Opened by Dominic Wild - 23.08.2012
Last edited by Andrew - 27.09.2012
Opened by Dominic Wild - 23.08.2012
Last edited by Andrew - 27.09.2012
FS#672 - "Snap to intersection" followed by "Dimension" does not seem to work?
Version 2.1:
Managed to use “Snap to grid” as the item was precisely 100mm or 120mm, but had it not been a precise multiple of 10mm there would have been a problem.
Thanks.
Closed by Andrew
27.09.2012 12:12
Reason for closing: Won't fix
Additional comments about closing:
27.09.2012 12:12
Reason for closing: Won't fix
Additional comments about closing:
Outdated QCAD version (2.1)
On windows 7-64 I cannot reproduce problem in either version 2 or 3.
Please outline clear steps so that I can test this further.