Centrepoint plus two points arc

Please use this forum to post feedback and suggestions related to QCAD.

Moderator: andrew

Post Reply
lesthegringo
Junior Member
Posts: 10
Joined: Sat Feb 02, 2019 12:06 pm

Centrepoint plus two points arc

Post by lesthegringo » Sun Feb 10, 2019 8:13 pm

Would it be possible to have an arc function where if you draw a circle, with lines that intersect it, to choose the centre, then select the intersections of the lines with the circle to define the arc? The same would apply for any intersections of course

Cheers

User avatar
Husky
Moderator/Drawing Help/Testing
Posts: 2490
Joined: Wed May 11, 2011 9:25 am
Location: USA

Re: Centrepoint plus two points arc

Post by Husky » Sun Feb 10, 2019 9:00 pm

None of the 10 QCAD Arc tools are working for that scenario? I doubt that but in the case that you actually need to use a circle then you could cut it (Divide tools) at the intersections.
Maybe you can post an example drawing to see the full picture?
Work smart, not hard: QCad Pro

Post Reply

Return to “QCAD Suggestions and Feedback”