Page 1 of 1

Printing drawings

Posted: Mon Jun 30, 2014 11:54 am
by Graham Wright
I have worked out how to do this once but have forgotten.
I have a two layer drawing where the base layer is a template to print on A4.
I need to scale another layer carrying the subject drawing so that it fills the page.

Re: Printing drawings

Posted: Mon Jun 30, 2014 1:11 pm
by andrew
Please refer to this forum thread for detailed printing instructions:
http://qcad.org/rsforum/viewtopic.php?f=32&t=2800

Re: Printing drawings

Posted: Mon Jun 30, 2014 2:19 pm
by Graham Wright
Thanks (again!).

After the first few words of your guidance, I remembered.

My version of QCAD is older than that in the example but the principle is the same.