Qcad 3.10.0 32bit on Win7sp1 64bit.
I want to use inches only, no feet. How do I get rulers and measurements at bottom of page to work this way?
Thank you.
[solved] Use inch only, not foot & inch
Moderator: andrew
Forum rules
Always indicate your operating system and QCAD version.
Attach drawing files and screenshots.
Post one question per topic.
Always indicate your operating system and QCAD version.
Attach drawing files and screenshots.
Post one question per topic.
Re: Use inch only, not foot & inch
Edit > Drawing Preferences > General > Drawing Unit:
Set units to 'Inch' and measurement to 'Imperial'. Edit > Drawing Preferences > Dimension > Dimension Settings:
Set linear dimension format to 'Fractional' or 'Decimal' (vs. Engineering or Architectural which show feet).
Set units to 'Inch' and measurement to 'Imperial'. Edit > Drawing Preferences > Dimension > Dimension Settings:
Set linear dimension format to 'Fractional' or 'Decimal' (vs. Engineering or Architectural which show feet).
Re: Use inch only, not foot & inch
Thank you. Very fast response. And solved my problems (after updating to 3.12.4.1, which I was going to do anyway).