[solved] Printing Page / wrong unit used

[Husky]

Printing Page / wrong unit used

Hi,
this is hunting me for a while and maybe somebody knows how to fix that.

Case:

General Drawing Units all imperial/inch,

Husky-2017.12.18-01.png (7.09 KiB) Viewed 2080 times

Mode_Space / Printing Page is using inch = perfect,

Husky-2017.12.18-02.png (28.26 KiB) Viewed 2080 times

Paper_Space / Printing Page is using mm. WHY? Ok, the conversion is correct but I need to see that in inch.

Husky-2017.12.18-03.png (28.91 KiB) Viewed 2080 times

And now the info what every Programmer is looking for: It is not stable in Paper_Space! It will change the unit on itself from mm to inch or back, always with the same Paper Size, correct value in mm or inch and ......................... I can't reproduce it! I can trigger that with switching back and forth between Model_Space and Paper_Space but I can't see a pattern.

Any Ideas?

[andrew]

Can you check if that problem is fixed in 3.19.2, thanks.

[Husky]

Can you check if that problem is fixed in 3.19.2, thanks.

Hmmm - til now it looks good! I tried hard but wasn't able to trigger it again. I'll keep an eye on it but I have a good feeling ....

Thank you very much for looking into this!