use mm in command
Posted: Fri Mar 30, 2018 7:03 am
Hi,
So, I have recently had a few issues with some drawings for my business. ( glass business) I need to draw parallelograms.
Ive been searching for the past couple hours on a way I can just input the millimetre measurements into the command.
Basically I need to draw shapes with height, width, angle, run measurements and level measurements.
The guys in at our manufacturer use a similar program and he was just entering eg. 1260 into the height etc into command and getting his desired outcome.
Is this something that is possible?
So, I have recently had a few issues with some drawings for my business. ( glass business) I need to draw parallelograms.
Ive been searching for the past couple hours on a way I can just input the millimetre measurements into the command.
Basically I need to draw shapes with height, width, angle, run measurements and level measurements.
The guys in at our manufacturer use a similar program and he was just entering eg. 1260 into the height etc into command and getting his desired outcome.
Is this something that is possible?