Hi again
Another strange pdf problem, I'm afraid. When I try to make a pdf, a few of my lines go missing (not many, but they are there for a reason!). It happens both on screen and on opening the pdf. I'd attach the dxf file, but it's larger than allowed (2.2MB), so instead I've attached a word document with a couple of screen prints.
I hope this has a very easy solution, and looking forward to hearing from you.
Jackie
[solved] pdf losing some polylines
Moderator: andrew
Forum rules
Always indicate your operating system and QCAD version.
Attach drawing files and screenshots.
Post one question per topic.
Always indicate your operating system and QCAD version.
Attach drawing files and screenshots.
Post one question per topic.
[solved] pdf losing some polylines
- Attachments
-
- pdf problem.docx
- (383.43 KiB) Downloaded 359 times
Re: pdf losing some polylines
dxf requested via PM.
Work smart, not hard: QCad Pro
Win10/64, QcadPro, QcadCam version: Current.
If a thread is considered as "solved" please change the title of the first post to "[solved] Title..."
Win10/64, QcadPro, QcadCam version: Current.
If a thread is considered as "solved" please change the title of the first post to "[solved] Title..."
Re: pdf losing some polylines
Hi Jackieh
Can you copy and paste only the problem lines/entities into a new drawing and upload for testing please.
Can you copy and paste only the problem lines/entities into a new drawing and upload for testing please.
For the best support please state your operating system, QCAD version and add any supporting DXF/DWG files, screenshots etc...
Re: pdf losing some polylines
Hi
I've attached the drawing, with just the lines, but the properties of have not been preserved - and it works fine in pdf. AS a result, in the original dwg, I changed one of the lines from dash to continuous and that was also fine. So, the problem seems to be with having a dashed line.
Looking forward to a solution!
Thanks, Jackie
I've attached the drawing, with just the lines, but the properties of have not been preserved - and it works fine in pdf. AS a result, in the original dwg, I changed one of the lines from dash to continuous and that was also fine. So, the problem seems to be with having a dashed line.
Looking forward to a solution!
Thanks, Jackie
- Attachments
-
- lines causing problems.dxf
- (105.19 KiB) Downloaded 367 times
Re: pdf losing some polylines
Solved ...
... after adjusting a few "Linetype Scales" it was working as expected.
... after adjusting a few "Linetype Scales" it was working as expected.
Work smart, not hard: QCad Pro
Win10/64, QcadPro, QcadCam version: Current.
If a thread is considered as "solved" please change the title of the first post to "[solved] Title..."
Win10/64, QcadPro, QcadCam version: Current.
If a thread is considered as "solved" please change the title of the first post to "[solved] Title..."