Hi Qcaders:
I'm a Qcad newbee interested in drafting for my home cabinetry projects. Here is a question:
I made a square that is 25 x 25 and then drew a 315 degree angle from the 12.5,25 point. The angle intersects that upper right corner of the square, and extends beyond the right- side of the square.
I want to:
1. trim the upper right corner of the square that is "cut off" by the angle, and then
2. trim the segment of the angle line that extends beyond the right-side of the square.
How do I do this? I'm new to Qcad and cad in general.
Thank you!
Phil Smith
Duluth, GA
How do I trim?? Query from a newbee
Moderator: andrew
-
- Newbie Member
- Posts: 3
- Joined: Sun Oct 28, 2007 2:10 pm
- Location: Duluth, GA
1. Use the CUT Tool. [di]
2. Cut the lines needed in parts with the scissor tool. Use [si] intersection points to match intersection lines. Then left click do the cut.
3. Then use DELETE to delete.
OR better and faster:
3. Use the TRIMM tool [d2].
Yes, [d2] is your friend here!
Check also http://www.flagsoft.ch/qcadtutorial/qcadtutorial.html for a few video online tutorials.
2. Cut the lines needed in parts with the scissor tool. Use [si] intersection points to match intersection lines. Then left click do the cut.
3. Then use DELETE to delete.
OR better and faster:
3. Use the TRIMM tool [d2].
Yes, [d2] is your friend here!
Check also http://www.flagsoft.ch/qcadtutorial/qcadtutorial.html for a few video online tutorials.
-
- Newbie Member
- Posts: 3
- Joined: Sun Oct 28, 2007 2:10 pm
- Location: Duluth, GA