QCAD.org Forum

Posted: **Wed Jun 25, 2008 12:51 am**

I am sure this has been covered many times but I am new to Qcad, in from R14, Where is the offset command, and is there a print friendly manual?

Posted: **Wed Jun 25, 2008 10:16 am**

roguepoint wrote:I am sure this has been covered many times but I am new to Qcad, in from R14, Where is the offset command,

Try the command 'offset' or Draw - Line - Parallel

roguepoint wrote: and is there a print friendly manual?

Offset