Making dotted lines

Use this forum to ask questions about how to do things in QCAD 2.1/2.2.

Moderator: andrew

Registered Member
Posts: 1
Joined: Mon Oct 13, 2008 3:28 pm

Making dotted lines

Postby Scotts » Mon Oct 13, 2008 3:32 pm

Good Morning,
How do I make a dotted line. Right now I can only figure out how to make a solid line. I am drawing an three line electrical diagram and want to make a dotted line for the neutral.

And how do I make a line green as in the ground wire?

User avatar
Site Admin
Posts: 4576
Joined: Fri Mar 30, 2007 6:07 am

Postby andrew » Mon Oct 13, 2008 3:50 pm

The keyword here is 'layers'. In CAD, line styles (line pattern, color, width) are controlled by the layer. Add a layer for all ground wires, give it the desired attributes and draw all ground wires on that layer.

If you own the book QCAD - An Introduction to Computer-Aided Design, please refer to page 54, the chapter about layers.

Return to “QCAD 2.1/2.2 'How Do I' Questions”

Who is online

Users browsing this forum: No registered users and 1 guest