I am new and I want to invite myself. My name is Wolfgang and I am using qcad for design of modell airplanes. the dxf files are used to mill it on a milling machine TRON+, which is currently build up. In the future i will give CAM-Expert a chance to do the job.
1) If we have an jpeg/raster Image and are willing to digitize it, then we will have to use splines. In normal use to design a fuselage of an airplane, you often only draw one side and simply mirror it to the other side. Because this digitizing is done by hand (clicking each point), we sometimes have to close the lines after mirroring it to get a closed curve. I did this by trim function. Obviously trimming of 2 splines does not work for me.
2) Modell airplane fuselage are often build with stringers, so I have to cut the above mentioned splines and insert a rectangle for the stringers. This also does not work, used function: insert in a spline.
Any proposals to do this?
THX in advance
If you are having problems with QCAD 2.1/2.2, post here. Please report bugs here.
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 5 guests