I thought I would share this laser cut file for a card stock lantern, quite simply just cut out the four sides, glue together and job done. I guess for the very skilled you could use a craft knife (be careful).
laser cut 'Lantern' file
Moderator: andrew
laser cut 'Lantern' file
Hi guys
I thought I would share this laser cut file for a card stock lantern, quite simply just cut out the four sides, glue together and job done. I guess for the very skilled you could use a craft knife (be careful).
I thought I would share this laser cut file for a card stock lantern, quite simply just cut out the four sides, glue together and job done. I guess for the very skilled you could use a craft knife (be careful).
- Attachments
-
- lantern .dxf
- (1.05 MiB) Downloaded 382 times
-
- lantern.png (45.12 KiB) Viewed 5972 times