Hello from Tasmania, Australia
Have been aware of QCAD for quite some time. Interested in the community version because of ability to run under Linux and available in the PCLinuxOS. I was pretty well setup using DraftSight free version and thought I had it well backed up, just in case something would happen.
It did bad luck and I lost 3 systems when hard disks failed. I have just installed QCAD and are trying to find enough time to become familiar with operation.
Needed for simple mechanical drawing work. I like what I have seen so far.
Tried to import one of my old reference files. Unfortunately failing and I have not yet found out why.
Post to this forum to introduce yourself to this forum if you are new here. You might want to include some information about the work you are doing or planning to do with QCAD.
1 post • Page 1 of 1