Page 1 of 1
Toolpath bug
Posted: Sun May 21, 2017 6:44 pm
by jvalencia
I selected some polylines (from exploded text) and created the tooltpaths.
Some of them are incomplete. I've attached the dxf.
- Untitled.png (10.2 KiB) Viewed 7551 times
Re: Toolpath bug
Posted: Mon May 22, 2017 8:06 am
by andrew
Please try increasing the Tolerance for joining segments under
Edit > Application Preferences > Modify > Offset
For example to 0.01.
Re: Toolpath bug
Posted: Mon May 22, 2017 5:32 pm
by jvalencia
At 0.1 tolerance I still see incomplete paths. But the result has improved on other letters.
- Untitled.png (10.97 KiB) Viewed 7534 times
Re: Toolpath bug
Posted: Mon May 22, 2017 5:38 pm
by andrew
Note that the path for the A letter looks correct to me (assuming you didn't choose any lead in / lead out).
Re: Toolpath bug
Posted: Tue May 23, 2017 7:55 pm
by jvalencia
mm you're right on the "A", I'm used to see start and end on the same point (the toolpath).