Updating plunge rate

Discussions around the CAM Add-On of QCAD.

Moderator: andrew

Post Reply
User avatar
Clive
Moderator / Drawing Help
Posts: 1314
Joined: Thu Aug 25, 2011 9:28 pm
Location: UK

Updating plunge rate

Post by Clive » Wed Aug 30, 2017 9:01 pm

I've noticed if I update the plunge rate for a cam tool it doesn't dynamically update toolpaths which are using the same tool - in this example T1.

I had to go through and update more than 20 toolpaths manually - should this be the case or am I missing something here?
CAM Q1.jpg
CAM Q1.jpg (67.44 KiB) Viewed 3753 times
CAM Q2.jpg
CAM Q2.jpg (11.71 KiB) Viewed 3762 times
For the best support please state your operating system, QCAD version and add any supporting DXF/DWG files, screenshots etc...

Post Reply

Return to “QCAD/CAM”