Updating plunge rate

Discussions around the CAM Add-On of QCAD.

Moderator: andrew

Forum rules

Always indicate your operating system and QCAD version.

Indicate the post processor used.

Attach drawing files and screenshots.

Post one question per topic.

Post Reply
User avatar
Clive
Moderator
Posts: 1329
Joined: Thu Aug 25, 2011 9:28 pm
Location: UK

Updating plunge rate

Post by Clive » Wed Aug 30, 2017 9:01 pm

I've noticed if I update the plunge rate for a cam tool it doesn't dynamically update toolpaths which are using the same tool - in this example T1.

I had to go through and update more than 20 toolpaths manually - should this be the case or am I missing something here?
CAM Q1.jpg
CAM Q1.jpg (67.44 KiB) Viewed 7123 times
CAM Q2.jpg
CAM Q2.jpg (11.71 KiB) Viewed 7132 times
For the best support please state your operating system, QCAD version and add any supporting DXF/DWG files, screenshots etc...

Post Reply

Return to “QCAD/CAM”